Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Before
After
Before
After
Before
AfterMr-Glass Patio Door Installation in Los Angeles: What to Know First
We install and replace Mr-Glass patio doors across Los Angeles as an independent Mr-Glass service provider, not a manufacturer affiliate. Most installations are completed in one day once the door is on site, and you’ll get a written price before any work begins. A standard Mr-Glass sliding patio door install in Los Angeles typically runs $450 to $1,100 in labor depending on the opening condition and door size, with the door itself priced separately through your supplier or ours.
This page is for Los Angeles homeowners who already own a Mr-Glass patio door or are considering one and need a crew that knows how these specific doors go in correctly. If you’ve got a Mr-Glass door sitting in the garage waiting for install, or an existing one that’s binding, leaking, or off its track, call us at (817) 686-2228. We’ll tell you straight whether it’s worth fixing or replacing.
Key Takeaways
- We’re an independent installer, not a Mr-Glass dealer or warranty agent. We work in your interest, not the manufacturer’s.
- Written price before work starts. Always. The number on the quote is the number on the invoice.
- Every Mr-Glass patio door installation is covered by our 365-Day Done Right Promise in writing.
- Mr-Glass doors have specific failure patterns in Los Angeles that generic installers miss.
- We stock eight manufacturer lines, so if Mr-Glass isn’t the right call, we’ll tell you and show you alternatives.
How Mr-Glass Products Fail – and How We Fix Them
Mr-Glass makes a serviceable door, but Los Angeles conditions expose weaknesses that a generic installer won’t catch. Here’s what we actually see on job sites, and what we do about it.
- Roller bind on the Classic Series sliding door. The factory rollers on the Classic Series are nylon, and years of Los Angeles grit (fine dust, mostly) wears them into an oval shape. The door gets heavier to move, then starts grinding. We replace the rollers with sealed-bearing stainless steel units that shed grit instead of eating it. This is a $180 to $320 fix, installed, and the door will glide like it did new.
- Bottom sweep rot on the 7000 Series. The 7000 Series uses a vinyl bottom sweep that channels water to the weep holes. In Los Angeles, the bigger problem is dry rot in the wood sub-sill underneath, because the original installer never flashed the rough opening. We pull the door, rebuild the sub-sill with pressure-treated stock and flashing tape, and reset the pan. A Mr-Glass door installed over a properly flashed opening won’t leak, but too many LA retrofits skipped that step to save an hour.
- Lock misalignment from frame racking. Los Angeles sits on clay soil that expands in winter rains and contracts in summer heat. Slab foundations move. When they move, the door frame twists and the Mr-Glass multi-point lock stops engaging. The door’s not warped, the house shifted. We can often correct this by re-shimming the frame and rehanging the panel, which is a half-day job and a lot cheaper than a new door.
- Fogged insulated glass in the Premium Series. The Premium Series uses dual-pane low-E glass (a thin coating that reflects heat while letting light through). If the edge seal fails, moisture gets between the panes and the glass hazes over. The frame is probably fine. We replace the insulated glass unit rather than the whole door, saving you about 60 percent on materials.
- Worn weatherstripping on older builders-grade Mr-Glass sliders. What you’ll notice is a draft or a visible gap at the meeting stile. What’s actually happened is the pile weatherstrip has flattened. Mr-Glass replacements are available, but the aftermarket silicone-bulb type lasts longer in LA’s UV exposure. We’ll install either, and the difference in price is roughly $15 per door. We’ll tell you which we’d put in our own house.
Our Mr-Glass Patio Door Installation Process
Here’s how a Mr-Glass patio door job runs with our crew, start to finish.
- 1
Call and describe the door. You reach a live person at (817) 686-2228. Tell us the series if you know it, or describe the door and we’ll identify it. We schedule a visit.
- 2
We inspect on site. We check the panel, the rollers, the lock, the weatherstripping, and the rough opening. We measure the opening ourselves. Measure it right, seal it tight, and the door does the rest.
- 3
You get a written price. Parts and labor on one line. The price does not move at the door. If we find something hidden, we stop and show you before touching it.
- 4
We source the right parts. OEM Mr-Glass parts when that’s what makes sense, quality aftermarket when it performs better. We explain the tradeoff before ordering.
- 5
Install and test. We set the door, shim the frame properly, flash the rough opening, seal it, and then run the panel through a full open-close cycle. The lock has to engage cleanly or we’re not done.
- 6
Walkthrough and your guarantee. We show you what we did, where the water goes, and how to adjust the rollers if you ever need to. Your written 365-Day Done Right Promise is in your hand before we leave.
What Mr-Glass Patio Door Installation Costs in Los Angeles
We give every job a written price before work starts, but here’s what to expect in the Los Angeles market for common Mr-Glass scenarios.
| Job | Typical Range | What Moves the Price |
|---|---|---|
| New Mr-Glass slider install (door provided) | $450 – $1,100 | Door size, opening condition, second story |
| Roller replacement, both panels | $180 – $320 | Roller type, panel weight |
| Frame re-shim and rehang | $250 – $500 | How far the frame has moved |
| Insulated glass replacement | $220 – $480 per panel | Glass size, low-E vs standard |
| Full tear-out and replace | $1,200 – $2,800 installed | Sub-sill condition, stucco repair, permits if structural |
What actually moves the number is the condition of the rough opening. A clean opening with original flashing is a two-hour install. A rotted sub-sill with water intrusion is a half-day rebuild. We’ll show you the difference before we quote. Call (817) 686-2228 for a free estimate, and you’ll have a fixed number before you decide anything.
Why Los Angeles Homeowners Call Meridian Windows & Doors for Mr-Glass Work
The name Meridian is a fixed line you measure everything against. That’s how we run an install. Our crew shows up when we say we’ll show up, the price is on paper before work starts, and the work is covered in writing for 365 days. If it fails within that year, we come back at no charge. No fine print about labor exclusions.
We’re part of the Garrison Partners family, held to The Garrison Standard since 2009. Every technician is background-checked and uniformed, so you know exactly who’s walking through your door. And we stock eight manufacturer lines including PGT, CGI, CWS, and ES Windows. If a Mr-Glass repair doesn’t make financial sense, we’ll tell you, and we’ll show you what does. Elliot Vance grew up in the Palms neighborhood and has spent the better part of two decades working doors across LA. We know how clay soil, fine dust, and the odd winter rainstorm treat a patio door, because we’ve fixed all of it.
FAQs
No. Meridian Windows & Doors is an independent installer and service provider, not affiliated with or authorized by Mr-Glass. That means our loyalty is to the door working correctly in your home, not to the manufacturer’s warranty process. We’ll tell you the honest truth about what a repair costs versus a replacement.
A standard same-size install is completed in one day in Los Angeles, assuming the rough opening is sound. If the sub-sill needs rebuilding or the frame has racked, you’re looking at a day and a half. We’ll give you a specific timeline in your written quote before any work starts. Call (817) 686-2228 and we’ll schedule the site visit.
We install and service per the manufacturer’s published installation specs, which is what any warranty administrator looks for. If a warranty claim is in your best interest, we’ll flag it and point you to the right contact. We don’t pretend to be a Mr-Glass warranty agent, and we won’t leave you holding a broken door while we play phone tag.
If the frame is straight and the glass is clear, repair usually makes sense. Swapping rollers, a bottom sweep, and weatherstripping costs a few hundred dollars in Los Angeles. If the frame is twisted, the glass is fogged, or the sub-sill is rotten, replacement is the more honest answer. We’ll walk you through the math on a free visit, no pressure, and the written price is yours to think about.
Common wear parts like rollers and weatherstripping are readily available within a few days through our local suppliers. Series-specific hardware, like a multi-point lock assembly, sometimes takes longer. We’ll tell you before we order if there’s a lead time, and we never start a job until all parts are in hand. Call (817) 686-2228 with your door’s series name and we’ll check availability right then.
Get Your Free Estimate
If you’ve got a Mr-Glass patio door that needs installation, repair, or an honest assessment, call (817) 686-2228. You’ll reach a person, not a recording. We’ll set a time that works for you, come out, measure the opening, and put a written price in your hand. No pressure, no price games, and a full year covered in writing.
Written by Elliot Vance, Owner, Meridian Windows & Doors at Meridian Windows & Doors, serving Los Angeles and nearby areas.